RepRap 3D Printer PCB Heatbed MK2B Heat Bed Hot Plate For Prusa Mendel 12V 24V

Description

RepRap 3D Printer PCB Heatbed MK2B Heat Bed Hot Plate For Prusa Mendel 12V 24V
All features from MK2A and you also can operate this board now with 12v or 24v
- a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity
- The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief.
Copper plated holes as shown in reprap wiki: reprap.org/wiki/PCB_Heatbed
You can find the open source files here:
http://forum.reprapdiscount.com/forums/oss/
Dimensions 214mmx 214mm
Laminate FR4 1.6+-0.15mm
2 layer, 35μm copper
Red Soldermask - both sides
White Silkscreen - both sides
Power Input: 12V or 24v
copper plated holes
resistance between 1.0 and 1.2 ohm
Very good in combination with
RUMBA
or
Taurino Power
All features from MK2A and you also can operate this board now with 12v or 24v
- a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity
- The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief.
Copper plated holes as shown in reprap wiki: reprap.org/wiki/PCB_Heatbed
You can find the open source files here:
http://forum.reprapdiscount.com/forums/oss/
Dimensions 214mmx 214mm
Laminate FR4 1.6+-0.15mm
2 layer, 35μm copper
Red Soldermask - both sides
White Silkscreen - both sides
Power Input: 12V or 24v
copper plated holes
resistance between 1.0 and 1.2 ohm
Very good in combination with
RUMBA
or
Taurino Power
Shipping Policy
Delivery Time
We ship to worldwide, it usually takes 10-30 Business Days to delivery.
Shipping address
We ship to your PayPal address. Please, make sure to provide us with correct, precise, and detailed shipping Address.
Send Time
Items will be shipped within 1 to 3 business days upon payment received or cleared.
Note
If you don't receive items over 30 business days, please notify us via eBay message.
Return Policy
We appreciate your business and offer an instant 7 days return policy.(7 days after receive the item). The returned item has to be in its original condition. We are able to refund your money without shipping cost.
Contact us
For anything about product, price, shipping or order status, please contact us via eBay message.
We love positive feedback and 5 scores DSR. We will leave it for everyone that leaves it for us.
Powered by SoldEazy
On Jul-19-17 at 06:43:22 PDT, seller added the following information: